[PLDWWW] page changed: docs:man:installing_pld_linux_based_on_rescue_cd

["Arkadiusz Miśkiewicz (arekm)"]

[Prepare to install kernel] 
 
--- https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?rev=1548095718
+++ https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?rev=1548096453
@@ -104,18 +104,37 @@
  
  
  ==== Prepare to install kernel ====
  
+ Before installing kernel you need to mount kernel proc, sys and dev filesystems inside of chroot:
  
  <file># mount -o bind /proc /pld/proc
  # mount -o bind /sys /pld/sys
  # mount -o bind /dev /pld/dev
  </file>
+ 
+ You need to tell initrd generator which hardware driver is needed to access your rootfs filesystem
+ by setting scsi_hostadapter alias in **/etc/modprobe,d/modprobe.conf** (or any other file in that directory)
+ 
+ <file>alias scsi_hostadapter ahci</file>
+ 
+ **lspci -k** command run on rescuecd can help you to find a correct driver:
+ 
+ <file>
+ 00:01.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
+         Kernel driver in use: ata_piix
+         Kernel modules: ata_piix, pata_acpi, ata_generic
+ </file>
+ 
+ Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix)
+ 
+ 
  Configure **/pld/etc/fstab** ex.: 
  
  <file>/dev/sda1 swap swap defaults 0 0
- /dev/sda2 /    ext3 defaults 0 0
+ /dev/sda2 /    ext4 defaults 0 0
  </file>
+ 
  \\ :!: Write something more here :!: 
  
  
  


Diff URL:
  https://www.pld-linux.org/docs/man/installing_pld_linux_based_on_rescue_cd?do=diff&r1=1548095718&r2=1548096453

-- 
This mail was generated by DokuWiki at
https://www.pld-linux.org/