udev hal modprobe cos nie tak ??
Tomasz Mateja
tommat w pimpek.one.pl
Pią, 28 Paź 2005, 18:19:04 CEST
Po podłączeniu dysku USB:
Oct 28 18:10:17 tommat kernel: usb 2-1: new full speed USB device using
uhci_hcd and address 2
Oct 28 18:10:17 tommat udev[5857]: run_program: exec of program
'/etc/udev/agents.d/usb/usb-storage' failed
Ręczne modprobe usb-storage:
Oct 28 18:11:01 tommat kernel: Initializing USB Mass Storage driver...
Oct 28 18:11:02 tommat kernel: scsi0 : SCSI emulation for USB Mass Storage
devices
Oct 28 18:11:02 tommat kernel: usbcore: registered new driver usb-storage
Oct 28 18:11:02 tommat kernel: USB Mass Storage support registered.
Oct 28 18:11:02 tommat kernel: grsec: denied resource overstep by
requesting 2145849344 for RLIMIT_STACK against limit 8388608 for
/[modprobe:5862] uid/euid:0/0 gid/egid:0/0, parent /bin/bash[bash:5681]
uid/euid:0/0 gid/egid:0/0
Oct 28 18:11:02 tommat kernel: grsec: denied resource overstep by
requesting 2145849344 for RLIMIT_STACK against limit 8388608 for
/[modprobe:5862] uid/euid:0/0 gid/egid:0/0, parent /bin/bash[bash:5681]
uid/euid:0/0 gid/egid:0/0
Oct 28 18:11:02 tommat kernel: usb-storage: device found at 2
Oct 28 18:11:02 tommat kernel: usb-storage: waiting for device to settle
before scanning
Oct 28 18:11:07 tommat kernel: Vendor: FUJITSU Model: MHT2040AT
Rev: 0022
Oct 28 18:11:07 tommat kernel: Type: Direct-Access
ANSI SCSI revision: 00
Oct 28 18:11:07 tommat kernel: usb-storage: device scan complete
Oct 28 18:11:07 tommat kernel: SCSI device sda: 78140160 512-byte hdwr
sectors (40008 MB)
Oct 28 18:11:07 tommat kernel: sda: assuming drive cache: write through
Oct 28 18:11:07 tommat kernel: SCSI device sda: 78140160 512-byte hdwr
sectors (40008 MB)
Oct 28 18:11:07 tommat kernel: sda: assuming drive cache: write through
Oct 28 18:11:07 tommat kernel: /dev/scsi/host0/bus0/target0/lun0: p1
Oct 28 18:11:07 tommat kernel: Attached scsi disk sda at scsi0, channel 0,
id 0, lun 0
Oct 28 18:11:08 tommat fstab-sync[5908]: added mount point /media/usbdisk
for /dev/sda1
Aktualne AC+Ready i586 na p3
--
Tomek
Więcej informacji o liście dyskusyjnej pld-devel-pl