eepro

[pickman]

----- Original Message -----
From: "pickman" <pickman w wp.pl>
To: "PLD" <pld-users-pl w pld.org.pl>
Sent: Saturday, June 08, 2002 7:28 PM


 Witam
Niestety znowu o eepro

 [root w benice root]# cat /etc/sysconfig/interfaces/ifcfg-eth0
 # name of the device
 DEVICE=eth0
 # IP addresses/address prefix
 # where prefix:
 # 24 - resembles netmask 255.255.255.0
 # 16 - resembles netmask 255.255.0.0
 # etc.
 # IPADDR may be either IPv4 or IPv6
 # you may have up to 256 addresses set up
 IPADDR=192.168.1.1/24

 # you may select which of the above addresses
 # is primary for this interface (it'd be IPADDR1 in the example below)
 IP4_PRIM_IF="1"ONBOOT=yes
 BOOTPROTO=none

 --<ciach>--
 reszta jest ustawiona na no

 --</etc/sysconfig/network>--
 NETWORKING=yes
 IPV4_NETWORKING=yes
 IPV4_FORWARDING=no
 HOSTNAME="benice"
 NISDOMAIN="groa"
 GATEWAY="192.168.1.1"
 GATEWAYDEV="eth0"

  ifconfig
 eth0      Link encap:Ethernet  HWaddr 00:A0:C9:28:15:B9
           inet6 addr: fe80::2a0:c9ff:fe28:15b9/10 Scope:Link
           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
           TX packets:0 errors:5 dropped:0 overruns:0 carrier:10
           collisions:0 txqueuelen:100
           RX bytes:0 (0.0 b)  TX bytes:358 (358.0 b)
           Interrupt:5 Base address:0x300

 [root w benice root]# cat /etc/modules.conf
alias usb-controller usb-uhci
 alias eth0 eepro
 options eepro io=0x300 irq=5

 [root w benice root]# /etc/rc.d/init.d/network restart
 Wylaczanie interfejsu eth0.........................................[
 ZROBIONE ]
 Ustawianie parametrów sieci........................................[
 ZROBIONE ]
 Podnoszenie interfejsu eth0........................................[
 ZROBIONE ]
 RTNETLINK answers: Network is unreachable
 ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
 ma ktoś jakiś pomysł ???
 z góry dzieki
 Łukasz