problemy z aha2910b

[Snurf]

Witam,

dostalem dzis do potestowania ten kontroler wraz z dyskiem
seagate ST34371N. Podpialem, do modules.conf dopisalem:
alias scsi_hostadapter aic7xxx_old

Gdy chce sie dostac do dysku wszystko dlugo stoi a potem
w logach pojawia sie cos takiego:

SCSI subsystem driver Revision: 1.00
PCI: Found IRQ 11 for device 00:0c.0
(scsi0) <Adaptec AIC-7850 SCSI host adapter> found at PCI 0/12/0
(scsi0) Narrow Channel, SCSI ID=7, 3/255 SCBs
(scsi0) Cables present (Int-50 YES, Ext-50 NO)
(scsi0) Downloading sequencer code... 415 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.4/5.2.0
       <Adaptec AIC-7850 SCSI host adapter>
blk: queue ce1f0b94, I/O limit 4095Mb (mask 0xffffffff)
  Vendor: SEAGATE   Model: ST34371N          Rev: 0484
  Type:   Direct-Access                      ANSI SCSI revision: 02
blk: queue ce1f0c94, I/O limit 4095Mb (mask 0xffffffff)
(scsi0:0:1:1) Synchronous at 10.0 Mbyte/sec, offset 15.
Attached scsi disk sda at scsi0, channel 0, id 1, lun 0
sda: Spinning up disk.......................................................................................................not responding...
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 28
Current sd00:00: sense key Not Ready
Additional sense indicates Logical unit is in process of becoming ready
sda : block size assumed to be 512 bytes, disk size 1GB.

i tyle...
Grzebalem w googlach ale nie znalazlem nic sensownego :(
Poradzcie cos prosze, co z tym zrobic?

kernel-2.4.20-6pl6_nogrsec

-- 
Pozdrawiam,
Piotr Koczur