xawtv - font

pbern@pbern.biz pbern w pbern.biz
Sob, 22 Sty 2005, 19:39:34 CET


On Sat, 22 Jan 2005, Michal Kochanowicz wrote:

> On Sat, Jan 22, 2005 at 07:23:29PM +0100, pbern w pbern.biz wrote:
>> tzn. tylko niebieski ekran z czestotliwosciami :<
>
> Podajesz typ karty przy ładowaniu modułu czy sam wykrywa?
sam wykrywa


Jan 22 20:41:19 pldmachine kernel: bttv: driver version 0.9.15 loaded
Jan 22 20:41:19 pldmachine kernel: bttv: using 8 buffers with 2080k (520 
pages) each for capture
Jan 22 20:41:19 pldmachine kernel: bttv: Host bridge needs ETBF enabled.
Jan 22 20:41:19 pldmachine kernel: bttv: Bt8xx card found (0).
Jan 22 20:41:19 pldmachine kernel: bttv0: Bt878 (rev 2) at 0000:00:09.0, 
irq: 10, latency: 32, mmio: 0xe2001000
Jan 22 20:41:19 pldmachine kernel: bttv0: detected: AVerMedia TVCapture 98 
[card=13], PCI subsystem ID is 1461:0004
Jan 22 20:41:19 pldmachine kernel: bttv0: using: AVerMedia TVCapture 98 
[card=13,autodetected]
Jan 22 20:41:19 pldmachine kernel: bttv0: enabling ETBF (430FX/VP3 
compatibilty)
Jan 22 20:41:19 pldmachine kernel: bttv0: gpio: en=00000000, out=00000000 
in=00fef7c3 [init]
Jan 22 20:41:19 pldmachine kernel: bttv0: Hauppauge/Voodoo msp34xx: reset 
line init [11]
Jan 22 20:41:19 pldmachine kernel: tvaudio: found tda9840 @ 0x84
Jan 22 20:41:19 pldmachine kernel: tuner: chip found at addr 0xc2 i2c-bus 
bt878 #0 [sw]
Jan 22 20:41:19 pldmachine kernel: bttv0: Avermedia eeprom[0x0297]: 
tuner=5 radio:no remote control:yes
Jan 22 20:41:19 pldmachine kernel: bttv0: using tuner=5
Jan 22 20:41:19 pldmachine kernel: tuner: type set to 5 (Philips PAL_BG 
(FI1216 and compatibles)) by bt878 #0 [sw]
Jan 22 20:41:19 pldmachine kernel: bttv0: i2c: checking for MSP34xx @ 
0x80... not found
Jan 22 20:41:19 pldmachine kernel: bttv0: i2c: checking for MSP34xx 
(alternate address) @ 0x88... not found
Jan 22 20:41:19 pldmachine kernel: bttv0: i2c: checking for TDA9875 @ 
0xb0... not found
Jan 22 20:41:19 pldmachine kernel: bttv0: i2c: checking for TDA7432 @ 
0x8a... not found
Jan 22 20:41:19 pldmachine kernel: bttv0: i2c: checking for TDA9887 @ 
0x86... not found
Jan 22 20:41:19 pldmachine kernel: bttv0: registered device video0
Jan 22 20:41:19 pldmachine kernel: bttv0: registered device vbi0
Jan 22 20:41:19 pldmachine kernel: bttv0: PLL: 28636363 => 35468950 . ok
Jan 22 20:41:19 pldmachine kernel: bttv0: add subdevice "remote0"


Pozdrawiam
Pawel Bernadowski
GG 3377, email kontakt w pbern.biz


Więcej informacji o liście dyskusyjnej pld-users-pl