PLD AC - macierz podłączona przez FC

[Krzysztof Opyrchał]

Arkadiusz Miskiewicz wrote:

> On Friday 11 of March 2011, Krzysztof Opyrchał wrote:
>> qla2300
> 
> Zobacz co powie:
> 
> modprobe qla2300
> 

teraz mam tak:

QLogic Fibre Channel HBA Driver
GSI 16 sharing vector 0xB1 and IRQ 16
ACPI: PCI Interrupt 0000:09:04.0[A] -> GSI 24 (level, low) -> IRQ 177
qla2300 0000:09:04.0: Found an ISP2312, irq 177, iobase 0xffffc20000006000
qla2300 0000:09:04.0: Configuring PCI space...
qla2300 0000:09:04.0: Configure NVRAM parameters...
qla2300 0000:09:04.0: Verifying loaded RISC code...
qla2300 0000:09:04.0: LIP reset occured (f7f7).
qla2300 0000:09:04.0: Waiting for LIP to complete...
qla2300 0000:09:04.0: LIP occured (f7f7).
qla2300 0000:09:04.0: LOOP UP detected (2 Gbps).
qla2300 0000:09:04.0: Topology - (Loop), Host Loop address 0x7d
scsi0 : qla2xxx
qla2300 0000:09:04.0: 
 QLogic Fibre Channel HBA Driver: 8.01.04-k-fw
  QLogic QLA2340 - 
  ISP2312: PCI-X (133 MHz) @ 0000:09:04.0 hdma-, host#=0, fw=3.03.18 IPX

nadal nie widzę zasobów.