PPPoE ifcfg-ppp0

[Krzysztof Szwaba]

Dnia 2012-01-03, o godz. 10:33:06
stacho <stacho w venco.com.pl> napisał(a):

> 
> Ja mam tak i działa:
> 
> DEVICE=ppp0
> ONBOOT=yes
> PPPOE_KERNEL=yes
> PPPOE_DEV=eth0
> AUTH=no
> PERSIST=yes
> DEFROUTE=yes
> USEPEERDNS=yes
> DEBUG=no
> PLUGIN_IFCFG_PASSWORD=yes
> PAPNAME=xxxxxx
> PASSWORD=xxxxx
> 
> Tylko login i hasło musiałem dać do chap-secrets.

dodanie do
/etc/sysconfig/interfaces/ifcfg-ppp0
wpisu
PPPOE_DEV=eth0.8PPPOE_DEV=eth0
powoduje:

Podnoszenie interfejsu
ppp0............................................................................................................................................[ PROBLEMY ]
Plugin ifcfg-password.so loaded. Plugin rp-pppoe.so loaded.
RP-PPPoE plugin version 3.8p compiled against pppd 2.4.5
/usr/sbin/pppd: unrecognized option 'eth0.8'
pppd version 2.4.5
Usage: /usr/sbin/pppd [ options ], where options are:
	<device>	Communicate over the named device
	<speed>		Set the baud rate to <speed>
	<loc>:<rem>	Set the local and/or remote interface IP
			addresses.  Either one may be omitted.
	asyncmap <n>	Set the desired async map to hex <n>
	auth		Require authentication from peer
        connect <p>     Invoke shell command <p> to set up the serial
line crtscts		Use hardware RTS/CTS flow control
	defaultroute	Add default route through interface
	file <f>	Take options from file <f>
	modem		Use modem control lines
	mru <n>		Set MRU value to <n> for negotiation
See pppd(8) for more options.

jak dam 
PPPOE_DEV=eth0
problemu nie ma ale wtedy nie mogę zestawić tunelu PPPoE bo nie trafia
do właściwego VLAN-u.
Czyżby skrypty nie przewidywały obsługi VLAN-ów ?
Jak sobie poradzić z tym problemem ?

Pozdrawiam
Krzysztof