Linux psuje płyty.

[Piotr Szymanski]

Hi,
Linux 2.6 (sprawdzalem na 2.6.4, 2.6.7, 2.6.11) robic cos takiego z płytami:
Nagrywarka bezbłędnie nagrywa z tą predkoscia pod windowsem. Nagrywarka jest 
IDE na czipsecie via82cxx, czy ktos ma pomysl jak to obejsc bez przechodzenia 
zupelnie na windows ?

***********
00:07.1 IDE interface: VIA Technologies, Inc. 
VT82C586A/B/VT82C686/A/B/VT823x/A/C/VT8235 PIPC Bus Master IDE (rev 10) 
(prog-if 8a [Master SecP PriP])
        Subsystem: VIA Technologies, Inc. 
VT82C586/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE
        Flags: bus master, medium devsel, latency 32
        I/O ports at c000 [size=16]
        Capabilities: [c0] Power Management version 2
***********

djurban w djurban tmp $ sudo cdrecord -v -v -v -v -v  dev=/dev/hda 
driveropts=burnfree -tao  sol-nv-b16-x86-v3.iso
Cdrecord-Clone 2.01 (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
cdrecord: Warning: Running on Linux-2.6.11.10-1
cdrecord: There are unsettled issues with Linux-2.5 and newer.
cdrecord: If you have unexpected problems, please try Linux-2.4 or Solaris.
TOC Type: 1 = CD-ROM
scsidev: '/dev/hda'
devname: '/dev/hda'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
Using libscg version 'schily-0.8'.
Using libscg transport code version 'schily-scsi-linux-sg.c-1.83'
Driveropts: 'burnfree'
SCSI buffer size: 64512
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'LITE-ON '
Identifikation : 'LTR-48246S      '
Revision       : 'SS0A'
Device seems to be: Generic mmc CD-RW.
Current: 0x0009
Profile: 0x000A
Profile: 0x0009 (current)
Profile: 0x0008
Profile: 0x0002
Drive current speed: 48
Drive default speed: 48
Drive max speed    : 48
Selected speed     : 48
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE FORCESPEED
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1422080 = 1388 KB
FIFO size      : 4194304 = 4096 KB
Track 01: data   629 MB
track: 1 start: 0 pregap: 150
Total size:      722 MB (71:36.56) = 322242 sectors
Lout start:      723 MB (71:38/42) = 322242 sectors
 41 00 00 14 00 00 00 00
 41 01 00 10 00 00 00 00
 41 01 01 10 00 00 02 00
 41 AA 01 14 00 47 26 2A
Track 1 start 0
Track 2 start 322242
 41 00 A0 00 00 00 00 01 00 00 00 00
 41 00 A1 00 00 00 00 01 00 00 00 00
 41 00 A2 00 00 00 00 71 38 42 00 00
 41 00 01 00 00 00 00 00 02 00 00 00
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 4
  Is not unrestricted
  Is not erasable
  ATIP start of lead in:  -11528 (97:28/22)
  ATIP start of lead out: 359842 (79:59/67)
Disk type:    Long strategy type (Cyanine, AZO or similar)
Manuf. index: 13
Manufacturer: Multi Media Masters & Machinary SA
Blocks total: 359842 Blocks current: 359842 Blocks remaining: 37600
Forcespeed is OFF.
Starting to write CD/DVD at speed 48 in real TAO mode for single session.
Last chance to quit, starting real write    0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Performing OPC...
Starting new track at sector: 0
Track 01:  115 of  629 MB written (fifo 100%) [buf  99%]  28.1x.cdrecord: 
Success. write_g1: scsi sendcmd: no error
CDB:  2A 00 00 00 E7 4A 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 00 00 00 00 0A 00 00 00 00 08 03 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x08 Qual 0x03 (logical unit communication crc error 
(ultra-dma/32)) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63488
cmd finished after 0.014s timeout 40s

write track data: error after 121262080 bytes
cdrecord: A write error occured.
cdrecord: Please properly read the error message above.
Writing  time:   48.571s
Average write speed 104.6x.
Min drive buffer fill was 98%
Fixating...
djurban w djurban tmp $ 

-- 
Piotr Szymanski
djurban w pld-linux.org