2 problemy

[Andree]

Witam
Moj kernel to 2.2.20-18 z pld i karta realtek RTL 8029 na ne2k-pci czyli to
co ma kolega
teraz polecenia cat /etc/sysconfig/interfaces/ifcfg-eth0 :
# name of the device
DEVICE="eth0"

# IP addresses/address prefix
# where prefix:
# 24 - resembles netmask 255.255.255.0
# 16 - resembles netmask 255.255.0.0
# etc.
# IPADDR may be either IPv4 or IPv6
# you may have up to 256 addresses set up
IPADDR="192.168.1.1"
#IPADDR1=192.168.0.2/24
#IPADDR2=192.168.0.3/24
#IPADDR3=192.168.0.4/24

# you may select which of the above addresses
# is primary for this interface (it'd be IPADDR1 in the example below)
#IP4_PRIM_IF="1"

# activate on boot? yes|no
# you must set it to 'yes' if you want to have this up after bootup
ONBOOT="yes"

# dhcp|pump|none
BOOTPROTO="none"
# Added by installer
PREFIX="24"


i cat /etc/sysconfig/network

# $Id: network,v 1.15 2001/11/05 16:58:50 kloczek Exp $
######################################################################
# MAIN PART

# Do you need IPv4 or IPv6 networking ?
NETWORKING=yes

# Do you need IPv4 networking ?
IPV4_NETWORKING=yes

# Do you want IPv4 forwarding ?
IPV4_FORWARDING=yes

# Set hostname here (only hostname)
HOSTNAME="Server"

# Set NIS domain name here
NISDOMAIN="localdomain"

# IPv4 gateway
GATEWAY="213.77.160.90"
GATEWAYDEV=""

# Do you want to use IPX networking ?
IPX=no
IPXAUTOPRIMARY=
IPXAUTOFRAME=
IPXINTERNALNETNUM=
IPXINTERNALNODENUM=

# Do you need IPv6 networking ?
IPV6_NETWORKING=no

# Do you want IPv6 forwarding ?
IPV6_FORWARDING=no

# Enable tunnel interfaces configuration ?
IPV6_TUNNELCONFIG=no

# IPv6 gateway
GATEWAY6=
GATEWAY6DEV=

# Global route for IPv6 host with IPv6 forwarding
IPV6_GLOBALROUTEGW=
IPV6_GLOBALROUTEDEV=

# Reading configuration from LDAP

# Do you want to use LDAP?
USE_LDAP=no

# What base DN use for searching for interface configuration
LDAP_BASE_DN=

# Other

# Do you want set static ARP table (based on /etc/ethers config file) ?
STATIC_ARP=no

# Do you want set static RARP table (based on /etc/ethers config file) ?
STATIC_RARP=no

# Specify interface on which you want to enable tleds software
# (also you need tleds package installed) -- default set to no
TLEDS_DEV=no

# This must be last line !
# vi:syntax=sh:tw=78:ts=8:sw=4

pozdrowienia Andree